X1 File

: Clean the plate with dish soap and water to remove oils, then apply a thin layer of glue stick if using the Cool Plate or Engineering Plate for better adhesion. Load Filament : Place your filament spool on the holder or in the AMS.

Peel off all and remove the protective cardboard around the print head. : Clean the plate with dish soap and

: Connect the ribbon cable and slide the screen into its front slot. : Connect the ribbon cable and slide the

: Unscrew the three screws located next to the lead screws (usually marked with arrows or labels) to allow the bed to move. Select on the screen; the nozzle will heat

: Ensure you select the correct filament type (e.g., Generic PLA) on the screen before starting.

Select on the screen; the nozzle will heat up and pull the filament through. Your First Print