Vd-tgm0001.rar

: Use fine-grit sandpaper (400 to 1000 grit) to remove support marks or "seam lines" where the mold halves met. 2. Test Fitting (Dry Fit)

: Most VD-TGM models use a "peg and hole" system. Test each connection before applying glue. VD-TGM0001.rar

: If a thin part (like hair or a sword) is warped, dip it in hot water for 20 seconds, gently bend it into the correct shape, and hold it under cold water to set. 3. Assembly Sequence For complex figurines, follow this order: : Use fine-grit sandpaper (400 to 1000 grit)

To put this piece together effectively, follow these general assembly steps for this type of kit: 1. Preparation and Cleaning Test each connection before applying glue

: If the parts were resin printed, ensure they are fully cured and washed. If they are physical resin cast parts, wash them in warm soapy water to remove mold release agents.

: For heavy parts (like a large cape or an outstretched arm), drill a small hole in both pieces and insert a trimmed paperclip or brass wire to act as a structural "skeleton" before gluing. 5. Gap Filling

: Save small accessories, hair strands, or weapons for last to avoid breakage during handling. 4. Adhesives