: Apply a "Constraint Displacement" or "Constraint Force" to the selected faces. 3. Common Troubleshooting
: Select the hole geometry where the insert will be placed. HUNTB-11103:25:57 Min
: Before reaching the 25:57 mark, you should have your primary 3D model or sketch ready for analysis or modification. : Apply a "Constraint Displacement" or "Constraint Force"
: If the operation fails at this step, check for "Non-Manifold" geometry in your base model. HUNTB-11103:25:57 Min
: Ensure you are in the correct module (e.g., FEM Workbench or Part Design) as indicated in the curriculum for the 11103 series.
For deeper technical dives, FreeCAD Forum users recommend following the Shawn Hymel / DigiKey series for the most up-to-date workflows.